V8 6.2L Simulation Engine Cover Radiator Motor Fan For 1/10 Scale Trx4 Jeep Land Rover D90/110/130 Rc Car Parts | Автомобили и

 

 

Attention when this product be equipped on for trx4 motor position:One side of exhaust manifold should be removed, that will let V8 engine to enough space to be installed.
You must cut part of the body posts and mounts to have enough space to the V8 engine.
DJC-0640 trx4 dashboard & DJC-0617interior can not be used when fix V8 engine on position, to have perfect effect, MUST apply the front-engine set(NOT INCLUDED), then DJC-0640&DJC-0617&V8 engine can work together perfectly.
Attention when apply front-engine set for trx4 use :Exhaust manifold should be removed, that will let V8 engine to enough space to be installed.
You can use DJC-0226 metal holder to have more space to let Exhaust manifold be equipped.
common use, can be applied on for trx4, scx10, scx10II motor, the OD of motor can be 36mm-38mm.
Temperature sensor with fan set inside, the fan will be activated when 35℃ above, and will stop when 25℃ below. High speed fan, with 25CFM plusmn10% wind flow;
Cylinder cap,ignition coil secondary cable,engine cover, exhaust manifold, air intake, common rail are heat-resistant ABS material(100℃ limited), can be painted as you like, cylinder block &oil level gauge are stainless steel material, heat sink is alu. material.
Design based on LS3 V8 6.2Lengine , simulated cylinder cap, ignition coil secondary cable, engine cover, exhaust manifold, air intake, common rail, cylinder block, oil level gauge details.
Length*width*height:63mm*71mm*52mm 
Color: picture color   6.2l  simulateur son moteur v8   rc 본넷  джип запчасти  cubre motor jeep  bmw قطع محرك  bmw вентилятор
Material: metal + plastic    v8 engine   engine scale  bmw a escala  bmw rc car  bmw rc car  rc e30  radiateur aluminium voiture  bmw rc toi
Package contents:1* set V8 6.2L Simulation Engine
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.