New Arrival Passive 10/100 PoE Extender POE Repeater RJ45 in/out 24v to 56v mode A or B Max Transmission 100M Distance | Безопасность и

New Arrival Passive 10/100 PoE Extender POE Repeater RJ45 in/out 24v to 56v mode A or B Max Transmission 100M Distance | Безопасность и

This device extends PoE power and data for 100 mtr past the standard. It allows power to be carried on 10/100 network cables and have that power and data extended another 100 meters. Compatible with Passive PoE switches or injectors with any CAT5e, CAT6 or CAT7 Ethernet network cable.

Intended for use with passive injectors or switches – this pass thru PoE solution uses some of the power to rebuild each data packet for error free retransmission another 100 meters. It is a compact and cost effective power solution. The PoE source supplies between 15 and 56 volts DC at the source location. 13 watts in delivers 12.5 watts out. Repeat each 100 mtr as needed.  24v systems might need our 29 volt injector to operate beyond 200 meters if the load is more than 6watts. The use of CCA Ethernet cable is not recommended. The PoE source can send either voltage polarity, and only 2 pairs are required. See also our GAT-Extender for gigabit speeds, and our UPoE models for power to 50 watts.

The device is symmetrical – either side can be used as the input or output.

Specifications

Power and data source:  RJ 45 PoE in – male or female

Data speed:  10/100

Power and data output:  RJ45 PoE out – male or female

Input Voltage: Max Up to 57 volts

Power usage:  always on, from 12v up

PoE Pass thru:  Passive, 24v to 56v , mode A or mode B

Internal power use:  500 mw

Operating Temperature:  0°C - 50°C

Ethernet switch:  IP175G as a 2 port, 802.3u fast low power switch

Vlan Support:  Transparent

Size:  95 x 24 x 31 mm plus 24 cm Ethernet cable.

PoE Power input Pins:  Any combination of pins – either polarity – mode A or mode B

PoE Power output pins:  Any combination of pins – either polarity – mode A or mode B

802.3af / 802.3at:  Transparent - no impact on client class

LED status on Female RJ45:  2 LEDs – one for each port to show an Ethernet connection