Automotive Oscilloscope Probe Hantek HT25 High Voltage Inductive Capacitance Ignition Probes Diagnostic-tool Accessories | Инструменты

Automotive Oscilloscope Probe Hantek HT25 High Voltage Inductive Capacitance Ignition Probes Diagnostic-tool Accessories | Инструменты

Automotive Oscilloscope Probe Hantek HT25 High Voltage Inductive Capacitance Ignition Probes Diagnostic-tool Accessories

Suitable for DS0201 DS203 DSOnano pocket oscilloscope probe to detect special car ignition

Car ignition is an inductive probe capacitance probe, it must be equipped with an oscilloscope

Used in combination, to test a spark plug ignition overlap wave, the second wave superimposed

parameters to achieve the detection, diagnosis engine ignition state, the ignition of each cylinder

so that the voltage changes with time from the visually displayed on an oscilloscope.

The pick-up line has three ends, a BNC connector is connected to the oscilloscope,

and a grounding for the clip, a clip connected to the high voltage used for pickup.

Picking up the clip is an attenuator for attenuating the low pressure picked to protect

from electrical shock oscilloscope.

Please note that the use of:

Package (airbubble envelop):

a kind of inductive capacitance sensor, it must match with an oscilloscope
Close to use, can be used to test a spark ignition secondary overlapping wave, overlapping wave parameters, thus achieved the detection, the diagnosis engine ignition position, make each cylinder ignition voltage changing with time directly from the oscilloscope display.

The loot line has three end, a joint meet oscilloscope for BNC use, a for use, a clip grounding to pick high-voltage gleaned clip with. Loot clincher over is a attenuator, used for loot high-pressure attenuation for low pressure, thus protecting oscilloscope not electrify impact.

When used please note:
(1)test clips shall not directly clip in spark plug, should be caught in the connection of the spark plugs of insulation wire, in order to prevent the breakdown and causing a shock.
(2)to distance other high-voltage at least 2 inches apart, lest produce interference.
(3)HT25 leading line length 2.5 meters, the decay of up to 10,000:1.